Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFAAC Keypad & Intercom Repair: The Waxahachie Owner’s Guide
FAAC keypad and intercom repair in Waxahachie typically runs $185 to $420 installed, depending on whether the keypad itself is failing or the intercom board has gone bad. We stock FAAC-compatible keypads, intercom modules, and wiring kits on most trucks, so most repairs are done in a single visit. The usual story we hear: a keypad that worked for eight years suddenly stops reading codes, or an intercom that crackles and cuts out right when a delivery driver is trying to reach the house.
What owners tell us first is often not “it broke.” It’s “it works sometimes.” That intermittent behavior is the classic signature of a failing FAAC board or a worn keypad membrane, and it’s the first thing we check.
Which FAAC Models This Applies To
We work on the FAAC keypads and intercoms most common across Ellis County driveways: the 404, 412, and 415 keypad lines, along with the XKP and DS-series intercom panels. If your system is a FAAC 455D, 400, E024, or 844 operator, the keypad wiring follows a similar two-wire or four-wire path, but the programming steps differ enough that matching the exact model number matters. The model label is usually inside the keypad housing or on the back of the intercom faceplate. Take a photo before you call us. It saves a return trip.
A real compatibility gotcha with FAAC: a keypad from a 455D system will not always talk correctly to an older 412 operator without a dip-switch change, and the wiring order matters more than most homeowners expect. We have seen handymen swap a keypad and leave the gate dead because two wires were reversed. When it comes to OEM versus aftermarket, we stock both. A genuine FAAC keypad costs more but matches the original wiring exactly. A quality aftermarket equivalent sometimes saves $60 to $90 and works fine on newer systems. We will tell you which one makes sense for your gate, not whichever one is on the truck.
Signs Your FAAC Keypad & Intercom Is Failing
- Dead keypad, no backlight, no beep. Usually a failed power feed or a corroded terminal inside the keypad housing. Waxahachie’s humidity and occasional hard freezes are rough on exposed outdoor terminals.
- Works first try, then stops for an hour. This is commonly a thermal issue on the intercom board. The board heats up, a solder joint expands, and the circuit opens. It cools, works again, and drives you crazy.
- Intermittent audio or a humming intercom. A failing capacitor on the intercom board or a ground loop in the wiring. We have seen both, and fixing the wrong one means the problem comes back in a month.
- Some codes work, others stopped working. A worn keypad membrane. Individual buttons die one at a time until the whole pad becomes unreliable. This is the single most common FAAC keypad failure we replace in Waxahachie.
- Gate opens on its own after a rainstorm. Water intrusion in the keypad or intercom housing causing false short signals. FAAC housings are generally well sealed, but after ten years the gasket hardens and cracks.
Replacement Cost & What’s Included
Here is what FAAC keypad and intercom work costs in the Waxahachie market, installed, with the price agreed before we turn a single screw.
| Job | Installed Price Range |
|---|---|
| FAAC keypad replacement (OEM) | $185 - $310 |
| FAAC keypad replacement (aftermarket) | $140 - $240 |
| FAAC intercom board replacement | $260 - $420 |
| Full keypad + intercom module swap | $380 - $560 |
| Diagnostic service call (applied to repair) | $89 |
The range depends on the FAAC model, whether we are replacing just the keypad or the intercom board behind it, and whether the existing wiring is still solid. Every quote is parts plus labor, fixed before we start. No surprises on the bill. Every job carries our 90-Day Done Right Promise in writing.
DIY or Call Us?
There are two things an owner can safely check before calling: whether the keypad has power at all, and whether the connections at the keypad terminals are tight and free of green corrosion. That is it. The moment you are opening an intercom enclosure and looking at a board with live low-voltage wiring, you should stop. A FAAC intercom board is not dangerous in the high-voltage sense, but a wrong connection can send voltage back into the operator board and turn a $300 repair into a $1,200 operator replacement. We have been called in after that exact mistake more times than we would like.
If it rolls, swings, or slides, we can tell you what is wrong with it - and whether it is worth fixing. Call (936) 226-3481 and Victor Salinas or one of our techs will walk you through the likely cause over the phone before we even schedule the truck.
FAQs
Seven to twelve years is typical in Ellis County. Sun exposure on a west-facing gate shortens it. The membrane is the first thing to go, followed by the terminal connections inside the housing. Call (936) 226-3481 for an exact quote on replacing yours after a quick model check.
Sometimes, but not often enough to recommend it. A corroded terminal can be cleaned and re-seated. A dead membrane cannot be rebuilt. If the board is failing rather than the keypad itself, board-level repair costs almost as much as a new module, and the new module carries a warranty. We will tell you honestly which path is cheaper over the long run.
Most FAAC keypad replacements take under an hour. An intercom board swap takes an hour and a half. If wiring needs to be pulled or spliced, add half an hour. We complete most jobs in a single visit.
Yes. We carry FAAC-compatible keypads, wiring kits, and intercom modules for the most common local models, along with parts for LiftMaster, Mighty Mule, and Ghost Controls systems. If we do not have your exact board, we can typically have it in hand within two business days.
Call Ironworks Gate Co. for FAAC Keypad & Intercom Repair in Waxahachie
If your FAAC keypad is dead, intermittent, or the intercom sounds like it is underwater, call (936) 226-3481. A live person answers, 24 hours a day, 7 days a week. We will ask for the model number, give you a straight answer, and schedule a time that works. Estimates are free. The price we quote is the price you pay, in writing, before the work begins. Serving Waxahachie and the surrounding Ellis County area for over 42 years, with fair pricing, a 90-Day Done Right Promise, and a 5% discount for seniors and veterans, always.
Written by Victor Salinas, Owner, Ironworks Gate Co., serving Waxahachie and nearby areas.