Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
BFT Keypad & Intercom Repair: The Waxahachie Owner’s Guide
BFT keypad and intercom repair in Waxahachie typically runs $225 to $485 installed, depending on whether we are replacing the keypad face, the intercom module, or the full weather-sealed housing. We keep the most common BFT keypad and intercom parts on the truck for the Rigel, Deimos, and Mitto lines, so most repairs happen in one visit. The way owners usually find the problem: the keypad buttons stop responding after rain, the intercom audio goes quiet on one end, or the gate stops recognizing codes that worked last week.

Texas weather is rough on outdoor electronics, and BFT keypads live their whole life outside. We have replaced enough of them in Waxahachie to know exactly what fails first, what is worth repairing, and when a new unit costs less than chasing an old one.
Which BFT Models This Applies To
This page covers the BFT keypad and intercom lines we service most often in Waxahachie: the Mitto series keypads (Mitto 2, Mitto 4), the Rigel 5, the Deimos BT and Deimos Ultra, and the older T-Box and DL series that still show up on gates installed fifteen or twenty years ago. If you are not sure which model you have, open the keypad’s outer face and look for a label on the back side of the circuit board or the inside of the housing. BFT prints the model and voltage there in small type.
A word on parts: BFT makes solid hardware, but the company has changed connector styles and mounting footprints between generations. A Mitto 2 keypad will not drop into a Mitto 4 backplate, even though they look nearly identical from the front. That is why we carry both new and refurbished BFT-original parts plus quality aftermarket equivalents from brands like Nice and FAAC-compatible lines we have tested here. For a Waxahachie homeowner, the right call is usually: BFT original for the control board and radio receiver, aftermarket for the keypad face and housing, where the price difference is big and the failure difference is small. Ironworks Gate Co. is an independent service provider, not affiliated with BFT, but we have been installing and repairing their automation for over two decades.
Signs Your BFT Keypad & Intercom Repair Is Failing
- Buttons need hard presses or specific angles. The rubber membrane under the keypad face breaks down, especially after a few Ellis County summers. Once the carbon contacts wear, the button can look fine and still fail to register a code.
- Codes work sometimes, then stop. The relay on a BFT keypad cycles every time the gate opens. After 50,000 or 60,000 cycles, that relay starts sticking. It is a $30 part inside a $40 keypad, and it is the number one reason codes go intermittent.
- Intercom audio dies or goes one-way. The BFT intercom modules use a small audio transformer and electrolytic capacitors that are vulnerable to heat and humidity. In Waxahachie, where we get both, these fail in predictable ways: the visitor hears nothing, or the homeowner hears nothing.
- Moisture inside the keypad or display. The weather seal on a BFT keypad is a rubber gasket. Once it hardens, condensation builds, the display fogs, and the board starts corroding. If you see moisture, the clock is ticking.
- The gate beeps but does not move when a code is entered. That usually points to the keypad working fine and the problem living downstream: the receiver, the control board, or a wiring fault. We diagnose this on site so you are not paying for a keypad that was never the issue.
Replacement Cost & What’s Included
Here is what BFT keypad and intercom repair actually costs in Waxahachie. These are installed prices, parts and labor together, quoted and agreed before any work starts.
| Repair type | Typical installed range | What drives the price |
|---|---|---|
| Keypad face and membrane replacement | $225-$340 | BFT original vs tested aftermarket, single- vs double-gang mounting |
| Keypad board or relay repair | $185-$280 | Part availability, board revision, soldering work if required |
| Full keypad replacement (new unit, installed) | $340-$485 | Model, whether it is a standalone keypad or part of an intercom system |
| Intercom module repair or replacement | $275-$475 | Module type, wiring run, whether the handset inside the house also needs replacing |
| Diagnostic visit (no repair done) | $89 | Applied toward the repair if you proceed same day |
Every repair carries our 90-Day Done Right Promise in writing. If it is not right, we come back and make it right. No paperwork, no arguing. Waxahachie homeowners also get $50 off any repair over $250, and we honor a permanent 5% senior and veteran discount. The price on the estimate is the price on the invoice, period.
DIY or Call Us?
BFT keypads and intercoms run on low voltage, which keeps the danger level well below what you would face with a gate motor or an opener arm. That said, a multimeter and a YouTube video will not tell you whether the problem is the keypad relay, the receiver, or the control board, and we have seen plenty of Waxahachie homeowners replace a keypad only to find out the real fault was a 12-volt transformer in the control box. The safe and useful checks you can do: look for moisture behind the keypad face, make sure the wire connectors at the back are seated, and test whether the same problem happens with a different code. Past that, the diagnostic tools and spares live on our truck.
If you want it fixed once and fixed right, call (936) 226-3481. A live person answers, 24 hours a day, every day of the week. Victor Salinas grew up a few miles from the Ellis County Courthouse square, and he has been repairing BFT automation around Waxahachie for well over two decades. If it rolls, swings, or slides, we can tell you what is wrong with it, and whether it is worth fixing.
FAQs
In Waxahachie, a BFT keypad typically lasts 6 to 9 years before the relay or the rubber membrane gives out. Intercom modules last about the same, with the capacitors usually failing first. Unshaded south-facing keypads and gates on gravel drives where dust works into the seal fail on the shorter end. Call (936) 226-3481 for an exact quote; estimates are free.
Often yes. Relay failures, membrane replacements, and corroded connectors are repairable, and that is usually the cheaper route. If the board itself is heavily corroded or the display is dead, a new unit usually costs less than trying to save the old one. Call (936) 226-3481 and we will tell you which side of that line your keypad falls on.
Most BFT keypad and intercom repairs in Waxahachie are done in one visit, typically 45 to 90 minutes on site. If we need a model-specific part that is not on the truck, you will know before we leave, and we schedule the return before we pull out of the driveway.
We stock the most common BFT keypads, membranes, relays, and intercom modules on the truck, along with tested aftermarket equivalents. We also keep parts for LiftMaster, Mighty Mule, and Ghost Controls, since many Waxahachie gates run more than one brand. If your part is not on board, we order it same day and return as soon as it lands.
Need a BFT keypad or intercom fixed in Waxahachie?
Call (936) 226-3481 now for a free estimate. You will speak to a person, not a voicemail, and we will give you an upfront price before any work begins. Ironworks Gate Co. serves Waxahachie, Midlothian, Red Oak, Ennis, Corsicana, and the surrounding Ellis County area, with over 42 years in the gate trade. Done right, and backed in writing.
Written by Victor Salinas, Owner, Ironworks Gate Co. at Ironworks Gate Co., serving Waxahachie and nearby areas.





Before
After
Before
After
Before
After