Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Waxahachie Owner’s Guide

Ghost Controls keypad and intercom repair in Waxahachie typically runs $185 to $420 installed, depending on whether we’re replacing the keypad face, the control board, or the intercom module, and most jobs are completed in a single visit. The usual discovery goes like this: the gate worked fine yesterday, and this morning the keypad beeps but nothing moves, or the intercom crackles, or a row of buttons stopped responding altogether. You’re not the first Ellis County homeowner to stand at the end of a driveway trying to remember a gate code that isn’t the problem. When a Ghost Controls keypad or intercom fails, the part itself is almost always the issue, not your programming, not the remote, and not the gate motor.

Call (936) 226-3481

Which Ghost Controls Models This Applies To

Ghost Controls builds its keypads and intercoms to work across the whole AXDP and TSS1 opener lines, and the same keypad family serves the sliding gate kits, the dual-swing kits, and the estate gate openers. That’s useful, because it means we can usually match a replacement without pulling the whole post apart. The compatibility gotcha most homeowners hit is the wire run: Ghost Controls keypads run on a standard 2-wire low-voltage circuit, but the intercom version adds a second pair, and if the original installer buried a single 2-conductor cable you can’t simply add the intercom feature later without running new wire. The other thing worth knowing is the difference between the OEM Ghost Controls keypad and the quality aftermarket equivalent. We stock both. The OEM unit carries the exact faceplate dimensions and the correct wiring pigtail, while the better aftermarket versions use the same mounting footprint and often outlast the originals in Texas sun because the buttons are sealed differently. We are an independent service provider, not affiliated with Ghost Controls, which means we recommend based on what holds up in Waxahachie weather, not on what the catalog says.

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

• Some buttons work, others don’t. Ghost Controls keypads use a membrane switch layer under the faceplate, and once a single row starts to lift or crack, dirt and moisture get in and the whole pad is on borrowed time. This is the most common failure we see in Waxahachie, usually after three or four Texas summers.
• The keypad lights up but the gate won’t respond. That points to the communication path between the keypad and the opener board, sometimes a failed relay inside the keypad, sometimes a nick in the buried low-voltage wire from edging or a weed trimmer.
• The intercom buzzes or hums constantly. That is a failing audio module or a loose ground connection at the keypad housing. It starts as a nuisance and then takes the whole intercom offline.
• Code works from the remote but not the keypad. When the remote opens the gate but the keypad doesn’t, the keypad’s onboard receiver or the code memory chip has failed. That distinction saves you from replacing opener parts you don’t need.
• You have to press a button hard or multiple times. That is the membrane wearing out, and the fix is a new keypad face, not a new gate motor. Pressing harder never fixes it, and eventually the button stops responding at all.

Replacement Cost & What’s Included

A Ghost Controls keypad replacement in Waxahachie generally lands between $185 and $320 installed. Adding an intercom module, or replacing a combined keypad and intercom unit, runs $280 to $420. The spread comes down to whether you’re replacing just the faceplate on an existing housing, the full keypad unit with new wiring, or the intercom board, and whether we’re pulling new wire through conduit or working with the existing run. You get the part, the labor, the wiring check, and the reprogramming of all your existing entry codes, all quoted as one number before we start. Every repair we complete is covered by our 90-Day Done Right Promise in writing, so if something isn’t right we come back and make it right, no paperwork and no arguing.

Key takeaways: Most Ghost Controls keypad and intercom failures are the part, not the opener. We stock OEM and quality aftermarket equivalents on the truck. Prices are quoted and agreed before any work starts. The work is covered by the 90-Day Done Right Promise.

DIY or Call Us?

A Ghost Controls keypad runs on low-voltage wire, so it’s not a shock hazard the way line voltage is, but the honest warning is this: a homeowner who opens that keypad housing without knowing how the membrane connector seats can crack the ribbon cable, and then a $200 keypad becomes a $350 repair with a new board. What you can safely check is the obvious: make sure the keypad lights up at all, check whether any wire is visibly pulled loose at the post base, and confirm the breaker for the gate opener hasn’t tripped. If the keypad is dead, cracked, sun-faded beyond reading, or the intercom sounds like a frying pan, call us at (936) 226-3481. We’ll tell you over the phone whether it sounds like a keypad, a wire, or a board, and we’ll be out when we say we’ll be there.

FAQs